@article{9218,
  author = {E. Baratte and L. Kuijpers and T. Silva and V. Guerra and M. C. M. van de Sanden and J. P. Booth and O. Guaitella},
  title = {Determination of the accuracy of actinometry and line ratio techniques in an O2 glow discharge: part I, Comparison of absolute oxygen atom densities with CRDS measurements},
  abstract = {The accuracy of oxygen atom density measurements in plasmas by optical emission actinometry was tested by comparison to simultaneous direct absorption measurements on the 1D2 -> 3P2 transition by cavity ringdown spectroscopy (CRDS). The accuracy of the latter technique depends only on the accuracy to which the transition probability is known. Measurements were performed on a glow discharge in O2 operating between 0.5 and 5 Torr, and using both Ar and Xe as the actinometer gas. The rate constants for electron impact excitation, and thus the actinometry calibration factors, were calculated from the (measured) reduced electric field using a Boltzmann equation solver (Loki-B). Several sets of cross-section were tested for the EEDF calculation and for the electron impact excitation to the specific levels of O, Ar and Xe used for actinometry. The best results were obtained with the IST Lisbon cross-section set for O2 and O, and the BSR500 excitation cross-sections for Ar and Xe. Good agreement with the CRDS trends and absolute values was observed when using Xe as the actinometer gas, whereas with Ar the trends were well reproduced but it was necessary to increase the electron impact cross-section of the transition Ar(1S0 -> 2p1) of the BSR500 database by a factor of 3+-0.3 to reproduce the absolute values.},
  year = {2025},
  journal = {Plasma Sources Science and Technology},
  volume = {34},
  pages = {in press},
  doi = {10.1088/1361-6595/ae24a9},
  language = {eng},
}