The remote handling compatibility analysis of the ITER generic upper port plug structure

TitleThe remote handling compatibility analysis of the ITER generic upper port plug structure
Publication TypeJournal Article
Year of Publication2014
AuthorsD.MS Ronden, A. Dammann, B. Elzendoorn, T. Giacomin, C. Heemskerk, D. Loesser, P. Maquet, J. van Oosterhout, S. Pak, C.S Pitcher, M. Portalès, M. Proust, V.S. Udintsev, M.J Walsh
JournalFusion Engineering and Design
Volume89
Issue7-8
Pagination1009–1013
Keywordsdiagnostics, ITER, Port plug, Remote handling
Abstract

The ITER diagnostics generic upper port plug (GUPP) is developed as a standardized design for all diagnostic upper port plugs, in which a variety of payloads can be mounted. Here, the remote handling compatibility analysis (RHCA) of the GUPP design is presented that was performed for the GUPP final design review. The analysis focuses mainly on the insertion and extraction procedure of the diagnostic shield module (DSM), a removable cassette that contains the diagnostic in-vessel components. It is foreseen that the DSM is a replaceable component – the procedure of which is to be performed inside the ITER hot cell facility (HCF), where the GUPP can be oriented in a vertical position. The DSM removal procedure in the HCF consists of removing locking pins, an M30 sized shoulder bolt and two electrical straps through the use of a dexterous manipulator, after which the DSM is lifted out of the GUPP by an overhead crane. For optimum access to its internals, the DSM is mounted in a handling device. The insertion of a new or refurbished DSM follows the reverse procedure. The RHCA shows that the GUPP design requires a moderate amount of changes to become fully compatible with RH maintenance requirements.

DOI10.1016/j.fusengdes.2014.03.012
Division

FP

Department

TP

PID

824a2060f85b5fd208bea4e2b4adac38

Alternate TitleFusion Eng. Des.
LabelOA
Attachment: 

Go back one page.